1 Visitor Messages

  1. View Conversation
    Hello Vanuk, I had some questions and concerns regarding your post in the guardian section.Not sure if trolling bro LOL! if you are...well done, if not keep reading but this is meant to be constructive and at the end of this, would like to try and help clear some of the muddy water together.

    How did you generate these formulae and why is polynomial function @ 6? I seriously doubt it was a fitted routine from actual data points from standardized parses. Also, the bottom formula shows there is an actual negative value for your first term.

    Calculating X - for combined curves ST/flurry you set that = 5MA, how did you come to this approximate conversion? I see that your axis stops @ 600% so this is the only reason i felt you weren't trolling. The real question to answer is set MA=600% and THEN allow other parameters to float...

    Any response would be appreciated man and as I mentioned in my opening, any collaboration/discussion is welcomed. Thanks for your time!

    -Clownshoe
Showing Visitor Messages 1 to 1 of 1
About Vanuk

Basic Information


About Vanuk
Character:
Darkholis
Guild:
Revenge
Server:
Crushbone

Signature


Statistics


Total Posts
Total Posts
150
Posts Per Day
0.07
Visitor Messages
Total Messages
1
Most Recent Message
07-30-2012 12:04 PM
General Information
Last Activity
01-05-2017 11:54 AM
Join Date
09-21-2011
Referrals
1

Sponsor Ads